Publicidad
Idiomas disponibles
Idiomas disponibles
3. Loosen the Miter lock handle.
4. Align the pointer and table to 0 degrees.
5. Tighten the Miter Lock handle.
6. Loosen the 4 fence screws (Pt. #24)
7. Place a set square against the fence and blade (avoiding the blade teeth) (Fig.10)
8. Adjust the fence until square.
9. Retighten the fence screws.
10.Adjust the pointer to read 0 degrees.
Blade Cutting Depth Adjustment (for use when trenching)
The blade is factory set to cut all the way through a piece of timber under normal use.
If you require a trench cut the blade can be adjusted to cut to your pre-determined
depth.
1. Disconnect from the power supply.
2. Lift the saw Arm
3. Adjust the depth cut (Trenching) stop screw to the desired position. (Fig.12)
Always Use clamp (Fig.1) to secure the material. This clamp can be moved to either
side of the table by loosening the locking knob. Ensure this knob is retightened
before using the saw. Support long lengths using roller support stands.
4. Check depth on waste timber before commencing.
Compound Miter Cuts
A compound miter cut uses a Miter cut and a Bevel cut together.
The main uses for this type of cut are: picture frames, cutting moldings, roof framing
and for making boxes with sloping sides.
It is advisable to make a test cut on a piece of scrap wood before cutting into your
actual work piece.
Basic Cross Cutting with Fixed Blade
1. Pull the release knob and lift the saw arm.
2. Loosen the Miter Lock Handle (Fig.6)
3. Move the table to the required angle.
4. Fully tighten the Miter lock handle. (If the table is not locked firmly it can result in
personal injury).
Always Use clamp to secure the material. This clamp can be moved to either side of
the table by loosening the locking knob. Ensure this knob is retightened before using
the saw.
Support long lengths using roller support stands.
5. Turn the Laser guide on. (Fig.13)
6. Align the marked location of the cut on the material with the saw blade.
7. Grasp the operating handle and squeeze trigger to turn on the machine.
8. Allow the machine to free run to its maximum speed before making the cut.
9. Make the cut.
10. Allow blade to completely stop before raising the arm to retrieve the work piece.
15
Publicidad
