Publicidad
Idiomas disponibles
Idiomas disponibles
Off reminder timer
You can set the timer from the air conditioner operation start time to the stop time.
NOTE
• The air conditioner starts operating, and after the set time has elapsed, the air conditioner stops operating.
Countdown of "Off reminder timer"
Operating
Stop
Starting
No time remaining in
operation
"Off timer"
• "Off reminder timer" does not operate in the following conditions.
When "Off reminder timer" is disabled, during abnormalities, in test mode, during function settings, while a timer
is set, and during central control (if "ON/OFF" is prohibited)
• When 2 remote control are connected, settings cannot be done on the "Follower remote control".
• The setting range of "Off reminder timer" is a minimum of 30 minutes and a maximum of 240 minutes.
• Push [
Return] to not fi x the changes, so conditions are as before changes, and return to the "Timer" screen.
• When "Off reminder timer" is "ON", then "
25-EN
1140602001_EN FR ES.indb 13
1140602001_EN FR ES.indb 13
1
In the "Off reminder timer" screen, push
[
] and [
] to select "Off reminder timer"
2
Push [
]
Pushing [
] cancels the settings.
3
Push [
] and [
] to select "Timer"
4
Push [
] and [
] to change the time
Times can be set in 10 minute intervals.
5
Push [
Set/Fix]
Return to the "Timer" screen.
" is displayed in the detailed display.
– 13 –
6
Louver direction
■
Individual louver (Select wind direction for each air outlet)
You can set the wind direction for each outlet of indoor units that have 4-way air discharge.
NOTE
• This function may not be available, depending on the model of the indoor unit.
• This function can only be set while the air conditioner is operating.
▼
4-way air discharge type
Electrical control
Receiver
box
installation
position
Refrigerant
pipe
Drain pipe
NOTE
• For models that "Individual louver" is not available, the message "No function" is displayed.
• Push [
] or [
] while swinging to stop the louver and cancel swinging, push [
an wind direction.
• For group connections, refer to the Owner's Manual for the wired remote control.
• "
" is displayed when "Louver lock" is set. That louver cannot do "Individual louver". Refer to "Louver lock
(Fixing the angle of the louvers)"
1
In "Menu", select "Individual louvers", and
push [
Set/Fix]
2
Push [
] and [
] to select louvers
Louver 1
Louver 2
Louver 3
Louver 4
All louvers
3
Push [
] and [
] to select wind
direction
For details, refer to "Changing the wind direction".
4
Push [
Return]
Return to "Menu".
▼
Compact 4-way air discharge type
Receiver
Electrical control
installation
box
position
Drain pipe
Refrigerant pipe
] or [
] again to select
4/22/23 4:50 PM
4/22/23 4:50 PM
26-EN
Publicidad
