Publicidad
Idiomas disponibles
Idiomas disponibles
4-way cassette type
When cooling
Point the louver horizontally.
When heating
Point the louver downward.
The louver automatically closes when running is
stopped.
In pre-heating mode, the louver points upward.
The swing indication appears on the remote
control even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
1-way cassette type
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the
floor.
29-EN
1140602001_EN FR ES.indb 15
1140602001_EN FR ES.indb 15
The louver automatically closes when running is
stopped.
In pre-heating mode, the louver points upward.
The swing indication appears on the remote
control even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
Under ceiling type
Vertical adjustment
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the
floor.
The louver automatically closes when running is
stopped.
In pre-heating mode, the louver points upward.
The swing indication appears on the remote
control even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
– 15 –
NOTE
When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
When the horizontal louver is pointing horizontally
in HEAT mode, the air may not warm up the room
evenly.
Floor Console Exposed type
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
When heating
Move the louver manually and point it downward to
send heated air to the floor.
Changing the air discharge
Follow the procedure below to change the air
discharge:
1
Remove the two fixing screws of the air
discharge. (The fixing screws are to be
reused)
2
Insert your hand into the air discharge and
pull it up slightly, then remove the air
discharge from the claw hook at the rear
side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to
the main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fixing screws so that it does not
come off.
4/22/23 4:50 PM
4/22/23 4:50 PM
30-EN
Publicidad
