Saeco MEGACOLD L Instrucciones De Uso página 77

MEGACOLD L– Issue 01
Command 58 Enabling the Slave mode from Stand-Alone:
To set the following option ONLY, you must
press the
consecutively, signalled by the sound of the
buzzer, to access the second menu level. The
display shows "Command 00". To exit
programming mode, press the button "ESC".
This is used to run a Stand-Alone as a Slave. If the
command is set at 1, the following operations must be
carried out.
•
Switch off the machine by means of the main switch
and pull out the power plug.
•
Disconnect the connector indicated by the arrow
branching from the socket JP9 from the main board.
•
Make the Master/Slave connection
by means of the serial cable, fitting
the connectors to the sockets on the
rear.
•
Nominate the machine by means of
the dip-switch on the electrical panel,
positioning the notch in the respective
position as in the figure below. To
access the electrical panel, see the
paragraph: ACCESS
ELECTRICAL PANEL
COOLING UNIT.
turn on again, and carry out the programming of the Master machine.
Command 59 Stroke counter :
If the command is set at 1, the stroke counter appears every time the door is opened.
"Programming Button"
TO THE
AND
twice
27
E
N
G
L
I
S
H