Before Start-Up - Fiac SSA 410 Manual De Uso Y Mantenimiento

GB
Remote signalling alarm
The dryer control board is equipped with a digital output for the remote signalling alarm. This digital output is controlled by a relays
configured as normally open: when an alarm is detected, this relays closes a circuit.
Proceed as follows to activate a remote alarm output:
1. The User must provide a signaller in compliance with output relays electrical features (solenoid coil, light bulb, acoustic
signaller, ...).
2. Disconnect the dryer from electrical power supply, remove cover and left side panel.
3. Connect the signaller to the terminal blocks (See PIC.2).
Alarm Output relays electric features:
250VAC / 3A – AC 15 (Amp. Inductive)
The activation of the above function is on User's discretion. The User will purchase all necessary installation
material by himself. Any operation which needs access to the dryer must be carried out by qualified personnel.

BEFORE START-UP

Before starting the machine, make sure that all operating parameters correspond to the nominal data.
The dryer is supplied already tested and preset for normal operation, and it doesn't require any
calibration. Nevertheless, it's necessary to check the operating performances during the first working
hours.
Start up
The operations specified below must be performed after the first start up and at each start up after a prolonged inactive period of time
due to maintenance operations, or any other reason.
1. Make sure that all instructions contained in chapters INSTALLATION SITE and INSTALLATION have been respected.
2. Check if by-pass is locked properly (if existent).
3. Activate current supply and press the ON/OFF switch on the control panel for at least 1 second.
4. Wait 5 to 10 minutes until machine has achieved its standard operating parameters.
5. Slowly open the air outlet valve and successively open the air inlet valve.
6. If existent, close the by-pass.
7. Check if the condensate drainer is working properly. Check if all connecting pipes are properly tightened and fixed.
Before disconnecting the dryer from electrical power supply, use ON/OFF key to stop the dryer. Otherwise wait
10 minutes before switching the dryer on again, in order to allow freon pression re-balance.
MAINTENAINCE, TROUBLESHOOTING AND DISMANTLING
Maintenance
Before attempting any maintenance operation, make sure that:
1. No parts of the system is under pressure.
PIC.2
24