Jay J2 Plus Back Manual Del Usuario página 4

ENGLISH
INSTALLING THE J2 PLUS BACK
The J2 Plus Back is designed to replace the wheelchair's sling
upholstery. The initial installation should be done as follows:
SIDE PLATE INSTALLATION
NOTE– Ensure the side plates are correct for 8° or straight back
canes.
Tools: 3/16 Allen wrench
NOTE– It is recommended that the push handles (E) be installed
in the tallest setting.
1. Remove the lower clamp assembly (A) from the left and
right side plate (D), set aside with attaching hardware (B).
2. Attach the left side plate (D) to the push handle by
loosening the upper clamp fastener to allow clamp (C) to
slide over push handle, loosely secure clamp to push
handle. Adjust side plate to the correct height, loosen and
tighten clamp as required. Repeat process for the right
side.
3. Install lower clamps by equally tightening the provided
fasteners so that the gap between side plate and the lower
clamp is equal from front to back. See figure.
J2 Plus Back 255197
The J2 Plus Back is designed to supply the clinician with
the means to provide the client with a back support that can
accommodate a heavier load capacity and provide all the
benefits of a solid back support.
Maximum User weight 650lbs (293Kg).
CAUTION
Installing a back support on a wheelchair may affect the center
of gravity of the wheelchair and may cause the wheelchair to tip
backwards potentially resulting in injury.
CAUTION
1. Maximum occupant weight for the J2 plus back is 650
lbs, the user should check weight restrictions of the
chair on which the back will be placed.
2. The J2 Plus back can be used up to 60 degrees tilt in
space for stationary applications.
3. While using a J2 Plus back on a tilt in space chair, the
chair should be returned to is upright position when the
occupant is being propelled.
Alwaysw assess the need for anti-tippers and amputee
axle adapter brackets to be added to the wheelchair to help
increase stability.
J2 PLUS BACK AND ACCESSORIES
E
D
C
B
A
Figure 1
4
TA B L E O F C O N T E N T S
I N S TA L L AT I O N
Equal gap
Equal gap
Figure 2 View from above
Rev.C