Jay J2 Plus Back Manual Del Usuario página 6

ENGLISH
4. Install the both left and right
retaining pins into the 12-degree
position(F) through the
sideplate(E), upper connector(A)
and into the back shell receiver(D)
Figure 7.
5. Adjust back shell to be centered
between side plates (G)
6. Tighten both upper connector
fasteners (H) while gently
holding the upper connector
inward towards the center of the
chair.
7. Tighten both lower connector
fasteners (I).
8. Back shell should rotate freely on
pins and be easily removable.
NOTE– Important: Ensure that the back
shell rotates freely and that the
upper connectors do not hit the
side plates. If required, adjust
the side plate angle to achieve
smooth operation.
SEAT TO BACK ANGLE ADJUSTMENT
(See Figure 11)
Tools: 3/16 Allen wrench
1. Remove the retaining pin (A) on each side plate.
2. Loosen the two fasteners (B) that hold the back shell
receiver for both sides.
3. Rotate the back shell and right back shell receiver to the
desired angle (C) and install retaining pin (A) through the
right side plate, upper connector and back shell receiver.
Repeat the process for the left side.
4. Tighten both fasteners (B) to secure the back shell
receiver on each side
VANITY FLAP ADJUSTMENT:
Tools: 5/32 Allen Wrench
1. Loosen the button head cap screw (A) on both hinges to
allow rotation of the vanity flap.
2. Rotate the vanity flap into the desired position.
3. Tighten both button head cap screws (A) to secure the
vanity flap in position.
J2 Plus Back 255197
+2
0
2 4
+3 +1
1 3
Figure 8
H
G
I I
Figure 9
Figure 11
6
I N S TA L L AT I O N
F
6 8
10
12
5 7
9
11
H
Figure 10
B
+2
C
+3 +1
A
Figure 12 Angle Positions
A
Figure 13
0
2 4
6 8
10
12
1 3
5 7
9
11
Rev.C