Jay J2 Plus Back Manual Del Usuario página 5

ENGLISH
4. Ensure both side plates are at the
same height (A) by measuring to
the bottom of the side plate from a
fixed location on the chair.
5. Adjust side plates to be parallel to
push handles when looking down
on the side plates from behind the
chair. Tighten upper and lower
clamps on both sides.
NOTE– For 8-degree side plates
adjust the side plate so that
the upper clamp fastener (B)
is in the approximately same
location of the slot for both
side plates.
NOTE– It is Important to ensure that
both left and right side plates
are installed at the same height
and parallel to the push
handles. Check that all
fasteners are tight before
moving on to the next step.
BACK SHELL INSTALLATION
Tools: 3/16 Allen wrench
1. Loosen the upper (A) and lower (B) connectors by loosening the two fasteners
that hold each connector to the back shell.
CAUTION– Loosen both fasteners equally to allow the connectors to freely slide
back and forth but do not remove the fasteners or loosen more than
required to achieve free sliding motion.
2. Place back shell onto chair by adjusting both lower connectors to fit over pivot
pins (C).
3. Adjust both upper connectors to fit into back shell receiver (D).
J2 Plus Back 255197
A
Figure 3
5
I N S TA L L AT I O N
PARALLEL
Figure 4
A
B
B
Figure 5
Figure 6
E
D
C
Figure 7
Rev.C