Jay J2 Plus Back Manual Del Usuario página 7

ENGLISH
GROWTH PLATE ADJUSTMENT:
(Allows growth of the back to the width of the chair.)
Tools: 5/32 Allen wrench
1. Loosen the two fasteners that secure each growth plate.(A)
2. Slide the growth plate (B) to the desired position.
3. Tighten the two fasteners (A) for each growth plate to secure in the desired
position.
LATERAL BRACKET INSTALLATION Figure 16
Tools: 5/32 Allen wrench
1. Remove existing growth plate (A) assemblies from back assembly, set aside
mounting hardware.
2. Install right side lateral assembly (B) with
longer mounting hardware (C), leave fasteners loose. Repeat procedure for left
side.
3. Slide growth plate / lateral assembly to desired position for both left and right
assemblies.
4. Tighten mounting hardware.
LATERAL BRACKET VERTICAL ADJUSTMENT Figure 17
Tools: 5/32 Allen wrench
1. Remove growth plate (A) and lateral assemblies (B) from back assembly.
2. Adjust lateral to desired vertical position.
3. Follow procedure for lateral bracket installation.
REMOVAL AND REPLACEMENT
Following installation and adjustment, the J2 Plus Back can be easily removed from the wheelchair if necessary. Simply remove
both left and right retaining pins. Rotate the top of the Back shell forward and lift the Back up and out of the wheelchair.
To re-install the Back, lower the back lower connectors to fit over the pivot pins. Rotate the top of the Back shell rearwards,
ensuring both the left and right side upper connectors have fitted into their respective back shell receiver. Secure the back shell
by installing both the left and right retaining pins through the side plate, upper connector and back shell receiver.
NOTE– The Back angle will not change when removed and re-installed on the wheelchair.
J2 Plus Back 255197
R E M O VA L A N D R E P L A C E M E N T
7
I N S TA L L AT I O N
A
Figure 14
B
Figure 15
C
B
A
Figure 16
B
A
Figure 17
Rev.C