Publicidad
Idiomas disponibles
Idiomas disponibles
• Press
to start the test. The equipment will start applying high
voltage and the high voltage LED (
test number will be displayed and then the measured resistance value:
Measured resistance
Applied voltage
Voltage selected
• Wait for the test to finish. The results screen will appear:
Measured resistance
Applied voltage
Capacitance
The capacitance value may take a few seconds to be calculated
6.4. Ramp test
• Access the device's MENU using the
• Use the control
• Use the control
• Configure the test parameters (see Setting the measurement modes,
item 5.2.4. Ramp mode, pg. 23).
R= 5.14GΩ
Ua:
505 V
Ut:
500 V
R: 5.12G
U: 2012 V
I: 392nA
SVT : 1.00
CAP: 100nF
, select MODE SELECTION and press
MODE SELECTION
SETUP TEST
LANGUAGE
, select RAMP TEST and press
=
SETUP TEST========
TEMPORIZED TEST
STEP VOLTAGE TEST
RAMP TEST
40
) will light up. The
Leakage current
97.9nA
Elapsed time
00:17
Elapsed time
Leakage current
01:00
button.
.
=
Voltmeter
Maximum voltage
Test duration
.
Publicidad
