EUFY Robovac Manual Del Usuario página 11

English
Remote Control
1 2
4
3
6
5
7 8
Install 2 AAA batteries before using the remote control for the first time. Make
sure the positive and negative ends are facing the correct polarity direction as
marked in the battery compartment.
Buttons & Indicators
Start/Stop Cleaning
Reset the Wi-Fi Connection (Press and hold for 10 seconds
until RoboVac beeps)
• Solid Blue: standby or cleaning
• Flashing/Solid red: error
*Refer to the "Troubleshooting>Error Tone" section in this
manual for solutions.
Spot Cleaning
• Flashing blue: Spot Mode
Return to Charging Base
• Flashing blue: returning to charging base
• Flashing orange: low power and returning to charging base
• Breathing orange (when docked to charging base): charging
• Solid blue (when docked to charging base): fully charged
• When you use the Find My Robot function via the EufyHome app, all three LED
indicators flash blue and RoboVac beeps once.
• To conserve power, all LED indicators automatically turn off when:
• RoboVac is not docked to the Charging Base and has been inactive for 10
minutes;
• RoboVac is fully charged for 10 minutes.
18
1
Return RoboVac to Charging Base
2
Adjust suction power level
3 Start Auto cleaning / Stop cleaning
4
Control cleaning direction manually
5
Start Auto cleaning
6
Start Edge cleaning
7
Start Spot cleaning
8 Start Quick cleaning
(Wi-Fi Status Light) Status
Slowly flashing blue Waiting for connection
Rapidly flashing blue Connecting with your wireless router
Solid blue Connected to your wireless router
Using Your RoboVac
Important Tips Before Use
a
b
d e
a
Remove power cords and small objects from the floor that may entangle RoboVac. You
can use the supplied cable ties to organize your wires and power cords.
b
Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored rugs or high-pile rugs thicker than 1.02 in/26 mm as they
may cause RoboVac to malfunction.
c
Keep RoboVac away from spaces lower than 2.87 in/73 mm to prevent RoboVac from
getting stuck. If necessary, place a physical barrier to block off the problem areas.
d
Keep RoboVac away from wet areas during cleaning. .
e
RoboVac may climb on top of objects less than 0.63 in/16 mm in height. Remove these
objects if possible.
English
c
f
19