EUFY Robovac Manual Del Usuario página 12

English
f
Anti-drop sensors can prevent RoboVac from tumbling down stairs and steep drops
in most cases. They may work less effectively if dirty or used on reflective/very dark-
colored floors. It is recommended to place physical barriers to block off areas where
RoboVac may fall, such as stairs covered by carpets or the rounded edges of wood floors.
Place physical barriers in front of fireplaces and areas that may cause damage to
RoboVac if entered.
Preparation
1
Install the side brushes before use.
2
Turn on the main power switch on the bottom of RoboVac.
Remove the sticker next to the power switch, and the foam blocks beside the
bumper before use.
20
3 Place the Charging Base on a hard, level surface and against a wall.
4
Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the front of
the Charging Base. If you cannot remove the objects, check whether RoboVac can return
to the Charging Base normally; if not, contact eufy customer service for help.
5
Connect the round connector of the adapter into the power socket on the Charging
Base and the other end into a wall outlet.
When the Charging Base connects to AC power, the LED indicator on the
Charging Base is SOLID WHITE.
- Install the Charging Base in a location that RoboVac
- Always keep the Charging Base plugged in, otherwise
Charge Your RoboVac
• RoboVac has a pre-installed rechargeable battery that has to be fully charged before
use.
• RoboVac returns to the Charging Base at the end of a cleaning cycle or when its
battery is running low.
English
can easily access. It is recommended to place the
Charging Base against a wall, and on a hard-level
surface rather than on rugs or carpets.
RoboVac will not automatically return to it.
21