Publicidad
Idiomas disponibles
Idiomas disponibles
Light
To switch on the light, press the
(on the tub edge).
To switch it off, press down the button until the light goes out.
It is possible to have either a white or coloured light; a light
which changes colour assuming different sequences is also
available.
The colour sequences are as follows:
- Cromodream (based on a mixed colour sequence);
- Relax (based on a blue colour sequence);
- Energy (based on a red colour sequence).
NOTE:
each sequence begins gradually then, after a few seconds,
reaches its characteristic intensity.
The individual colours:
- white;
- turquoise;
- green;
- orange;
- violet.
To move from one colour to the next, or to change the se-
quence, repeatedly press the
Where the water level in the tub is below that required for
hydromassage, the light will function at reduced power.
IT IS also possible to turn on the light when the tub is empty, us-
ing it as a courtesy light (the light will function at reduced power
in this context too).
Sanitization
We recommend the J-MX 07
able at the Assistance Centres/Authorised Retailers, is used to clean
the tub hydraulic circuit (approximately once a month dependent
on how often the hydromassage is used).
IT is possible to carry out this cleaning operation using the
same water used for the hydromassage provided that soap, oils,
cosmetics,have not been used; otherwise, empty the tub and fill it
once again.
In any case, the tub water level (free of concentrates) must be ap-
proximately 5-6 cm above the highest jets.
(*) Product not available in all Countries
Pour 50-100 ml of J-MX 07 liquid into the tub.
Activate the hydromassage for just over 1 minute and then
turn the pump off; leave the liquid to take effect for at least a
further 10 minutes.
button for a few seconds
button.
(*)
liquid, offered by Jacuzzi and avail-
Activate the hydromassage again for just over 1 minute and
then turn the pump off.
Open the drain and empty the tub.
Troubleshooting...
The hydromassage does not activate
- Check that the main switch is on.
- Press down on the button for a few seconds and then release it.
- Insufficient water level (when attempting to activate the func-
tion, the light flashes).
Fill the tub to the level indicated (refer to the Chapter, "Hydromas-
sage") and press the button once again.
The hydromassage stops of its own accord
- If the water falls below the minimum level (e.g. drain open), the
pump stops (the light flashes).
Fill the tub to the level indicated (refer to the Chapter, "Hydromas-
sage") and press the button once again.
Not many air bubbles come out of the larger hydromassage
outlets
- Check that the nozzles are open (refer to the Chapter, "Hydro-
massage").
The "strength" of the hydromassage has got weaker
- Check that the nozzles are open (refer to the Chapter, "Hydro-
massage").
- Clean the air and hydromassage outlets (refer to the Chapter,
"Maintenance").
The display does not receive commands
- If two keys are accidentally pressed at the same time, no func-
tion is activated.
You will need to wait three seconds before giving a new command
- If the display is covered by a layer of water, it may not receive commands.
Just wipe the water off with the palm of your hand and wait about
3 seconds before giving another command.
Maintenance
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
Cleaning the suction inlet
Remove any residue and wash the various components with wa-
ter and soap.
27
Publicidad
