Yakima GroundControl Manual Del Usuario página 11

start here to
extend Your
(installed)
base unit.
Begin at STEP 1
if this is a new
installation, and
refer to STEP 29.
27
reMove horiZontal hoops
• If coupler housings remain attached to hoops,
detach the housings by pulling them from the hoop.
• Leave couplers attached.
29
asseMble extended horiZontal hoops
30
continue at step 2
1033348B-11/45
25
clear the unit
Remove gear and accessories
from the installed unit.
• Add horizontal tubes to the connectors attached to the
GroundControl horizontal tubes.
• Depress the connector peg and slide all the way into the tube
until it clicks into the corresponding hole.
• Slide the remaining side tubes onto the connectors.
• ASSEmBlE vErTICAl POlES
• DrIll, ATTACh unIT wAll
• InSTAll hOOPS
26
28
reMove side tubes froM
the side that will extend.
exTenDeD
horizonTAl
hoops
loosen couplers
Use the 5/32" hex wrench
included with the Base Unit to
loosen the coupler screws and
open all couplers.
• Depress pegs on the
horizontal tubes and pull
side tube away from hoop.
• Leave connectors in the
side tubes.