Yakima GroundControl Manual Del Usuario página 5

5
6
assemble vertical sleeves onto foot tubes.
8
asseMble vertical connectors.
• Enclose the metal tube inside the two
halves of the vertical sleeves.
• Align the two notches to form a circular
hole. (This hole should align with the holes
running down the side of the vertical tube.)
1033348B-5/45
asseMble feet
Check that nut and bolt on foot is tight. If the
bolt or nut is loose, use a wrench to tighten.
• Attach rubber foot pad in the bottom of the
foot disk.
• Screw the threaded end of the foot tube all
the way onto foot disk, but do not tighten.
7
combine foot tube
assemblies to
vertical tubes.