Publicidad
Idiomas disponibles
Idiomas disponibles
13
position vertical
asseMblies on wall
• Stand the completed vertical tube assemblies
against the wall. Holes should be to your left.
• Position vertical assemblies so that the holes of
the wall plates line up with studs at 32" inches
apart.
• Mark location of the wall plate holes with a
pencil (32" apart).
• CHECK THAT MARKS ARE LEVEL.
corner Kit:
step 32 for measurements.
15
uneven floors
If your floor is uneven, adjust the
height of the feet until unit is level.
• Determine which side will need to be raised.
Turn foot disk until system achieves level.
• If system cannot be made level by extending
the feet, you can use one or more shims to
adjust the height of the system.
• Make shims large enough to cover the
bottom of the foot.
16
uniQue wall conditions
mountIng to
bare studs
Mount the system
as you would to a
standard wall. If
studs are not located
precisely where you
want to install the
system, use Universal
Mounting Plates at
both locations.
1033348B-/45
14
drill holes
Move the vertical assemblies
aside and drill starter holes into
the studs using a 1/8 inch drill bit.
If studs are not located precisely
where you want to install the
system, use the Universal
Mounting Plate.
If mounting to masonry or
concrete, you must use the
Anchor Kit (#05111).
do not extend
foot over 1/2"
Half concrete or
masonry walls
It may be necessary
to add a wood spacer
to accommodate the
difference in wall
depths. Concrete or
masonry requires the
Anchor Kit. Follow
Anchor kit instructions.
cautIon:
Publicidad
