Yakima GroundControl Manual Del Usuario página 8

17
attach top tubes
to walls
• Secure the vertical
assemblies to the wall
through the bottom holes of
the wall plates.
• Do not tighten yet.
• Leave the top holes empty.
do not
tIgHten
19
couplers
• LOOSEN the screws on the
couplers.
• Slide the coupler housings
off the sleeves.
• Open the coupler sleeves.
20
attach couplers
• Make sure the sleeve screws hang down.
• Align the peg on the inside of the sleeve with
the hole in the vertical assembly tube.
• Close the sleeve around the tube.
Close sleeve...
1033348B-8/45
18
sleeve
screw
Attach housing...
attach strut tubes to walls
• Secure the struts to the wall through the
bottom holes of the strut wall plates.
• Leave the top holes empty, do not tighten yet.
sleeve
housing
start at the top, skipping
a hole each time.
Open housing.
32"/81.28 cM
cHeck tHe
dIstance agaIn
oPen
sIx
couPlers
on eacH
Pole