Yakima GroundControl Manual Del Usuario página 14

33
existing installations reMove hoops, then side tubes —
(new installations begin at step 1)
If you have an installed base unit and you are adding a corner kit
and base unit, you must detach the standing unit from the wall.
34
asseMble corners and hoops
35
set these aside
make sure tHat tHe
Peg Holes face tHe
wall, otHerwIse
tHe couPlers wIll
not close ProPerly.
36
continue at step 13 to attach the unit to the wall.
assistance is recommended when installing the corner/hoop assemblies onto the
vertical assemblies.
1033348B-14/45
• Slide one connector onto each
corner tube.
• Depress the connector peg and slide
all the way into the tube until it clicks
into the corresponding hole.
• Add horizontal tubes to the side tube.
• Connect the half-hoops to the
corners.
Assistance is recommended when installing the
corner/hoop assemblies onto the vertical assemblies.
Attach the vertical assemblies to the wall (Step 13).
corner with extender Kit:
all corner tubes must be
attached directly to vertical
tubes on both sides.
corners AnD
horizonTAl
hoops