Yakima GroundControl Manual Del Usuario página 4

asseMble horiZontal hoops
insert connectors into each end of side tube.
• Depress the connector peg and slide until the peg
clicks into the corresponding hole in the side tube.
(See figure).
• Slide horizontal tubes onto the connectors at both
ends of the side tube.
• Depress connector peg and slide until the peg
clicks into the corresponding hole on the horizontal
tube.
• Insert connectors into the ends of horizontal tubes.
• Slide a second side tube onto the ends of the
horizontal tubes to complete one hoop.
2
attach wall plates to top tubes
or use Mounting plate
• Place the wall plate onto the threaded
end of the top tube, parallel to the tube.
• The convex bumps of the plate should go
into the end of the top tube.
• Secure with plate screw.
3
assemble vertical sleeves onto top tubes.
1033348B-4/45
extender Kit:
step 25 to add extensions.
corner Kit:
step 34 for adding corners.
If your wall studs are not
If you are using Universal
attach the oval wall plate
4
combine top tubes
to vertical tubes.
Holes should be
to the left!
32" apart, you must use
the Universal Mounting
Plate (#05103).
Mounting Plate, do not
to the top tube.