EVA Stampaggi EVSL8 Manual De Instrucciones página 33

Installation, use and maintenance manual
---- - WOOD BURNING STOVES
3 issuing of additional documentation - the installer's responsibility. The release of technical documentation must include:
● use and maintenance manual for the appliance and the components of the system (e.g. smoke channels, chimney flue,
etc.);
● photocopy or photograph of the chimney flue plate;
● system manual: (if applicable);
4 control and maintenance - the responsibility of the maintenance technician who must ensure care and maintenance of the
product during its use over time. The operator assigned to the control and maintenance of the systems for winter and
summer air conditioning, performs these activities to a professional standard, in compliance with the current legislation.
The operator, at the end of the same operations, must prepare and sign a technical control report in accordance with the
models provided for by the rules of this decree and by the implementing rules, in relation to the types and potential of the
system, to be issued to the person who signs a copy for receipt and acknowledgement.
In addition to what is specifically provided for in the following paragraphs of this Instruction Manual, the Purchaser must
comply with the following minimum installation requirements:
a) Do not invert or place the stove horizontally on one side;
b) The power of the stove must be adapted to the size of the room where it is to be installed and the room must be ventilated
from the outside;
c) The assembly of the flue pipe must be carried out in a workmanlike manner and according to European (UNI 10683) and
national regulations, local regulations and the technical specifications and warnings contained in this Instruction Manual;
d) The smoke outlet must be connected to the flue pipe by means of telescopic fittings;
e) The diameter of the flue must be less than 150 mm.
f) The connection to the flue pipe must be made with an inclination connection of less than 45°;
g) The flue pipe must be suitably insulated;
h) The minimum slope of the horizontal section must be 5%
i) The chimney and/or flue pipe must be waterproofed;
j) The flue shall not have more than two changes of direction;
k) The flue gas must be discharged directly into the flue pipe;
l) The flue gas duct must have a length of less than 6.0 m before the flue, with a maximum horizontal section of 3.0 m;
m) The flue and flue duct must not narrow in width from the initial diameter for its entire length. The initial diameter shall be
that of the exhaust outlet of the stove body;
n) The minimum value of the ventilation duct opening must be 80 cm²;
o) The distance of the flammable walls must be respected, as prescribed on the "stove data plate";
p) The burn pot must be cleaned before each ignition of the stove.
ATTENTION ATTENTION
The Buyer must not make any structural changes to the stove and must not make any operating changes to the
electrical board.
Installation and connection must be carried out by the Purchaser and by qualified technical personnel, in compliance
with European (UNI 10683) and national regulations, local regulations and assembly instructions contained in this
Instruction Manual.
Eva Stampaggi S.r.l. assumes no criminal and/or civil liability, direct and/or indirect, for damage to persons or
property resulting from non-compliance with the aforementioned provisions of law, assembly instructions, warnings
and general safety rules indicated in this Instruction Manual.
Failure to comply with the installation requirements and/or tampering with the stove may result in: inadequate power
and/or abnormal product behaviour, poor flue gas draught, clogging of the fire pit, slow combustion, tank fire,
overheating and fire hazard of the stove, fire hazard of the flue gas duct, lack of oxygen in the environment where the
stove is located.
Eva Stampaggi S.r.l. assumes no criminal and/or civil liability, direct and/or indirect for the malfunction of the stove
and for damage to persons or property caused by non-compliance with the requirements for installation of the stove
and/or tampering with it.
The Buyer must request and retain the certification of compliance of the installation, and the connection of the stove,
with the provisions of law. In the absence of such certification Eva Stampaggi S.r.l. assumes no criminal and/or civil
liability, direct and/or indirect for the malfunction of the stove and for damage caused to persons or property, resulting
from the use of the product.
ATTENTION ATTENTION
Warning: in the event of a power failure or electrical blackout, the burn pot must be emptied before repeating the
operation. Failure to follow this procedure may cause the door glass to break.
83103600 - 1.0 - 14/12/2022
EN EN
7 7