Publicidad
Idiomas disponibles
Idiomas disponibles
Installation, use and maintenance manual
---- - WOOD BURNING STOVES
Example of ignition from above:
Load the combustion chamber first with the largest logs of wood and above with strips of dry wood to facilitate ignition.
Arrange the wood as shown in the photo, leaving space between one log and another. Place the fire lighter on top of the wood
and start.
Do not add any more wood until the load has been consumed. Close the adjustment devices if the fire has ignited well.
If the wood is damp or the flue does not have much draft, it is advisable to leave the door ajar. The moment you close it and
the fire tends to go out, reopen the door and favor the complete ignition of the initial charge.
6.2
6.2
COMBUSTION
COMBUSTION
To obtain the best combustion, follow the parameters below:
Amount of wood (kg/h)
Primary air register
Secondary air
adjustment device
Refuelling interval (min) 45
Wood log length (cm)
Draught (Pa)
Once the product has started and reached full capacity it will be possible to adjust the combustion through the secondary air
adjustment device located at the top of the stove for EVSL105S, while for the other stoves it is possible to adjust the
combustion with the adjustment device located at the bottom of the stove.
When refilling with wood it would be advisable to open the secondary air adjustment device (NOT THE PRIMARY ONE).
Slightly open the door so that the stove takes in oxygen, load the wood and close the firebox door. At the time of refilling there
should be no lit fire in the chamber as, depending on the efficiency of the fireplace, there may be a loss of fumes into the
environment generated by the fire. Therefore, refilling is only recommended when there are embers burning on the fire bed.
83103600 - 1.0 - 14/12/2022
EVSL8
2,4
Closed
Open 100%
25
10
EVSL105S
2,9
Closed
Open 100%
45
33
10
EVSL5
1,4
Open 4 mm
Not adjustable
45
20
10
EN
EN
EVSL6
1,8
Open 4mm
Not adjustable
45
25
11
16
16
Publicidad
