EVA Stampaggi EVSL8 Manual De Instrucciones página 41

Installation, use and maintenance manual
---- - WOOD BURNING STOVES
6 6 PRODUCT USE PRODUCT USE
6.1 6.1 POWER ON POWER ON
The first ignition after installation must be performed with very little wood. This is used to understand if the installation
has been performed correctly and there is no loss of smoke and for settling of the product structure.
To light the stove, small (dry) logs and possibly ecological fire-lighters are required. Open the primary and secondary air
adjustment device using the levers and position the logs as in the photo. After positioning the logs, position the fire lighter and
start it. Close the door and wait for the flame to ignite all the wood logs positioned, then close the primary air adjustment
device. Failure to close this adjustment device could cause the stove to overheat and its parts to break.
Good ignition depends very much on the draught of the flue pipe: if the ignition is difficult, the flue pipe will not have the
recommended draught due to the fact that it is cold and the stove will require more time to reach the intended operating
conditions.
In this case, we recommend that you open the ash drawer or keep the fire door slightly open.
ATTENTION ATTENTION
NEVER use flammable liquids to ignite the wood logs
100% open in this position
Primary air adjustment device: 100%
open in this position
ATTENTION ATTENTION
The metal structure is coated using high temperature paints. When using the appliance for the first few times,
unpleasant odours may be given off due to the paint of the metal parts that is drying: this is in no way dangerous and
in such case, simply ventilate the premises. After the first heating cycles, the paint will reach its maximum adhesion
and all its chemical and physical features.
Do not use alcohol, petrol or other highly inflammable liquids to light the fire or poke it during operation.
It is also possible that the product may undergo slight deformations, as the structure is made of steel, and therefore
slight noises or crunches may be heard. This is absolutely normal and should not be considered a defect.
Encourage a change of air and good ventilation to the environment where the stove is installed.
Introduce a small amount of wood into the stove for the first ignitions and subsequent refills.
83103600 - 1.0 - 14/12/2022
Primary air adjustment device: 100%
open in this position
Door half-closed
Secondary air adjustment device: 100%
open in this position
Secondary air adjustment device: 100%
open in this position (EVSL105S)
EN EN
15 15