Publicidad
Idiomas disponibles
Idiomas disponibles
Installation, use and maintenance manual
---- - WOOD BURNING STOVES
ATTENTION
ATTENTION
Read the manual carefully:
Before installing, the following indications must be met:
Select the position where the stove is to be installed and:
●
Arrange the connection to the vent pipe for fume extraction.
●
Arrange the external air intake (combustion air).
●
Arrange the connection to the earthed mains.
●
The electrical system of the room where the stove is to be installed must be earthed, otherwise the control board may not
work properly.
●
Place the stove on the floor in a convenient position for the connection to the vent pipe and close to the combustion air
intake.
●
The appliance must be installed on a floor with an adequate loading-bearing capacity. • Should the existing floor not
comply with the requirement above, proper measurements must be taken (for instance, the installation of a load
distribution plate).
●
All the structures which could catch fire if exposed to excessive heat must be protected. Floors made from wood or
inflammable materials must be protected using non-combustible materials (e.g. 4mm-thick sheet metal or ceramic glass).
●
The appliance installation must ensure easy access for cleaning the stove, exhaust pipes and vent pipe.
● ●
This appliance is not suitable to be installed on a shared vent pipe.
This appliance is not suitable to be installed on a shared vent pipe.
●
During normal operation, the stove draws air from the room where it is installed. Therefore, an external air intake must be
positioned at the same height of the pipe located on the stove back. Exhaust fume pipes must be suitable for pellet stoves
and must therefore be made from coated steel or stainless steel, with a diameter of 8cm and fitted with adequate gaskets.
●
The "air combustion" socket must reach an external wall or a wall of an adjacent room with external ventilation, as long it is
not a bedroom or bathroom, nor at risk of fire such as garages, storage rooms, combustibles stores, etc. These air vents
must be made in such a way that they cannot be blocked either internally or externally and should be protected by a grille,
e metal net or other suitable protection without reducing the minimum dimensions.
4.5
4.5
AIRTIGHT STOVE ONLY
AIRTIGHT STOVE ONLY
Hermetic stove information:
Airtight stoves take combustion and glass cleaning air directly
from outside, not from the room where they are situated, if
correctly attached by a suction tube. In this way, no oxygen is
consumed from the immediate environment. Using coaxial
tubes the air will be pre-warmed contributing to improved
combustion and lower emissions into the atmosphere. Ideal
for passive houses, they offer best comfort at the lowest cost.
The stove works even if not connected to the external air
intake.
Using coaxial tubes the air will be pre-warmed contributing to
improved combustion and lower emissions into the
atmosphere.
In any case, comply with the National provisions for
installation with coaxial pipes.
83103600 - 1.0 - 14/12/2022
EN
EN
11
11
Publicidad
