BABY FAS – Issue 04
6.3
INSTALLATION
The vending machine must be installed on a surface (floor, intermediate floor) of suitable bearing capacity.
The appliance is not suitable for external installation as it must not be exposed to direct
sunlight or be installed where water jets may be used. The appliance is suitable for
installation in locations where the ambient temperature ranges between 3°C and 32°C.
1) Ensure that the fuses are securely in place.
2) The equipment must be supplied with single-phase voltage 230V 50Hz.
The appliance must be connected to a power supply mains featuring earthing which
complies with current legislation. The manufacturer recommends providing an electric
power supply mains for the vending machine which is equipped with a disconnecting
device having a contact opening of at least 3 mm. Ensure that the plug is accessible after
installation. It is strictly forbidden to use extension cords, adaptors or multiple jacks.
As the colour of the wires in the cable of this equipment may not correspond to the
colour marking in the terminals of your socket, proceed as follows:-
The GREEN and YELLOW wire must be connected to the socket terminal marked with
the letter E or with the GREEN or GREEN and YELLOW earth symbol. The BLUE wire
must be connected to the socket terminal market with the letter N or coloured BLACK or
BLUE. The BROWN wire must be connected to the socket terminal marked with the
letter L or coloured RED or BROWN.
The manufacturer cannot be held responsible for damages caused by the failure to
observe the precautions given above.
3) After having positioned the machine, adjust the four adjustable feet so that the machine is perfectly
horizontal; all the feet must be in contact with the floor.
4) Make sure there is a proper air circulation in the refrigeration unit. Leave at least 10÷15 cm between the
rear of the machine and the wall and check that the nets behind and under the radiator of the fridge are
always clean and not choked. If the machine is inserted into a piece of furniture of wood or similar, always
leave the rear net and the lower sides of the machine free in order to get a good air circulation.
5) Switch on the machine by inserting the plug into the socket. If the message "MEMORY CLEARED"
appears on the display, press the pushbutton located on the main board inside the coin mechanism box.
The vending machine will automatically start a self-test. If no errors are identified, the machine is ready
to use.
6) Programme the machine (see paragraph Programming procedure) and set the prices.
7) If the machine is supplied with a change giving coin mechanism, load change into the tubes.
8) Load the product into the machine (see paragraph Product loading procedure).
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
The following instructions are valid only to the United Kingdom
The wires in the cable are coloured coded as follows:
GREEN AND YELLOW - EARTH ---- BLUE - NEUTRAL ---- BROWN - LIVE
11
E
N
G
L
I
S
H