Use Of Coinmechanism Bdv 001 - FAS BABY Manual De Instrucciones

30
8.5

USE OF COINMECHANISM BDV 001

Installation: To connect the coin mechanism ask the manufacturer for the suitable connection cable (code
300238). After having carried out the connection, switch on the machine, enter the programming and set
command 69 to 4, then switch off the machine for some seconds. By switching it on again the machine and
the coin mechanism will communicate correctly.
Command 27
Command 30
Command 31
E
Command 32
N
Command 33
G
Command 34
L
Command 35
I
Command 36
S
Command 37
H
Command 38
Command 39
Command 27 Setting the signal for payment system out of order:
If the command is set at 1, when the connection with the BDV 001 payment system is interrupted the
vending machine goes out of order and the message appears on the display; if the command is set at 0
(zero), the option is disabled. The default setting is 0.
Command 30 Purchase obligation before return:
By setting this command to 1 the customer is obliged to purchase before receiving back the return. This is to
avoid to use the coin mechanism as a coin-changer. If the purchase fails to happen, the return will be given
out.
Command 31 Maximum credit:
The maximum credit accepted by the coin mechanism is set. By overtaking this value the acceptance of
further coins is blocked.
Command 32 Maximum value of returned coins:
This function is active only in multi-sale. If the value of the credit which remains after a sale is higher than the
value set by the command, the allotment of return will be blocked. Therefore it will be necessary to carry out
further purchases until the remaining credit will be lower than the set value. By moving the return lever it will
be possible to obtain the return.
Command 33 Inhibition single coins:
The acceptance of particular coins by the coin mechanism will be blocked through this command. If you want
to block the acceptance of coin 5, proceed as follows:
1. Programming mode, display views............................................................................................. Command 00
2. Dial 33 and press B, display views ................................................................................................ Coin no. 00
3. Dial 5 and press B, display views ...................................................................................................................0
4. Dial 1 and press B.
Command 34 Coin inhibition with exact amount:
This command blockes the acceptance of particular coins in case of small return, i.e. when the display views
the message "Insert only exact amount".
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
WARNING: The coin mechanism must only be connected/disconnected with the
machine switched off.
Setting the signal for payment system out of order
Purchase obligation before return
Maximum credit
Maximum value of returned coins
Inhibition single coins
Inhibition coins small return
Coin level message exact amount
Equation exact amount
Enabling credit card reader
Emptying of change giving tubes
Filling up of change giving tubes
To set the following option ONLY, enter the "programming mode" and when the
message "command 00" appears on the display press the "test" button again for a
further 3 seconds, after which the buzzer will sound again for a few seconds, and
access to the second level of the menu is obtained. The message "Command 00" will
appear again. To quit the programming mode press the "A" key .
BABY FAS – Issue 04
(def. 0)
(def. 0)
(def. 0)
(def. 0)
(all enabled)
(all enabled)
(def. 0)
(def. 0)
(def. 0)