Procedure For Removing The Trays (Fig. 12) - FAS BABY Manual De Instrucciones

36
9.3

PROCEDURE FOR REMOVING THE TRAYS (FIG. 12)

E
N
G
L
I
S
H
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
To replace the tray, proceed as follows:
1) Open the main door.
2) Disconnect voltage by removing the power supply plug.
3) Disconnect the electrical connector -A-
4) Remove the tray by overcoming the pull of the sliding rails (pull gently)
5) Pull out the tray up to the stop, lift it up and remove it from the machine.
N.B.: When removing the tray, ensure that the wire does not slip into the
space between the tray and the wall and that it is not stretched excessively
When taking the tray out or inserting it, especially if it is full of items,
handle it with care. Tilt it appropriately and insert the runners in the guides
correctly (see figure) without forcing, otherwise there is a risk of damaging
the front runners and/or the slide guides, especially when these actions are
repeated.
To assemble a tray, proceed as follows:
1) Insert the tray.
2) Push the tray until the sliding rails are engaged in the blocked position.
3) Insert the electrical connector -A-.
4) Supply voltage by inserting the power supply plug.
5) Close the main door.
FIG. 12
BABY FAS – Issue 04