Publicidad
Idiomas disponibles
Idiomas disponibles
ABYSS IP66 Installation Instructions
REMOTE CONTROL (Fig.15)
1. Open the battery compartment cover and insert 1 x 23A 12V battery(included). Note the correct battery polarity
(+/-) when inserting the battery, and then replace the cover and secure.
2. Follow the guide below to operate the fan and learn the functions.
The remote has memory function. If the fan or light is turned off by the isolating switch over 7
seconds, the next time to turn on the fan or light will be on last setting.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
NOTE: The pairing of the remote and receiver has been done at the factory.
When the ceiling fan is installed, pairing the fan receiver and remote is NOT required.
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC
ceiling fan remote and receiver.
Issues:
•
Loss of control - Fan is only running at high speed after installation.
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with the receiver.
9 | P a g e
USING YOUR CEILING FAN
1. ON/OFF the fan
2. Speed of the fan
3. Direction of the fan (reverse switch)
4. *Decrease light brightness
5. *Increase light brightness
6. *ON/OFF the light
7. *Light colour temperature
*No function for models without light
Fig. 15
Publicidad
