Publicidad
Example:
To stop the air conditioner 2 hours after setting and start it again 10 hours after setting.
1. Press the TIMER OFF button.
2. Press the TIMER OFF button again to display 2.0h on the TIMER OFF display
3. Press the TIMER ON button
4. Press the TIMER ON button again to display 10h on the TIMER ON display
5. Wait for one second and the digital display area will show the temperature again. The TIMER ON OFF
indicator remains on and this function is activated.
G
NOTE!
• If the same time is set for both START and STOPPING settings, the stopping time will
automatically increase 0.5hr (the set time displays less than 10hr) or one hour (the set time
displays 10hr or more).
• To change the Timer on/off time, just press the corresponding TIMER button and reset the
time.
• The setting time is relative time. That is the time set is based on the delay of the current time.
WARNING
• Keep the remote controller away from all liquids.
• Protect the remote controller from high temperatures and exposure to radiation.
• Keep the indoor receiver out of direct sunlight or the air conditioner may malfunction.
E
MANUAL OPERATION (WITHOUT REMOTE)
How to operate your unit without the remote control.
In the event that your remote control fails to work, your unit can be operated manually with the MANUAL
CONTROL button located on the indoor unit. Note that manual operation is not a long-term solution, and
that operating the unit with your remote control is strongly recommended.
G
BEFORE MANUAL OPERATION
Unit must be turned off before manual operation.
Manual
control
button
Manual control button
CAUTION
The manual button is intended for testing purposes and emergency operation only. Please do not
use this function unless the remote control is lost and it is absolutely necessary. To restore regular
operation, use the remote control to activate the unit.
To operate your unit manually:
1 . Locate the MANUAL CONTROL button on the right-hand side panel of the unit.
2 . Press the MANUAL CONTROL button one time to activate FORCED AUTO mode.
3 . Press the MANUAL CONTROL button again to activate FORCED COOLING mode.
4. Press the MANUAL CONTROL button a third time to turn the unit off.
4
95
Publicidad
