Publicidad
Idiomas disponibles
Idiomas disponibles
CD DIGITAL OUT
(OPTICAL)
--
VIDEO/AUX
_MD
--
LINE OUT
SUPER
WOOFERS
Refer to the operating
instructions
of the connected
equipment
for details.
• The connecting
cords are not supplied.
Obtain
the necessary
connecting
cords.
• Consult your local Aiwa dealer for optional
equipment.
VIDEO/AUX
JACKS,
MD JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono
plugs to connect
audio equipment
(turntables,
LD players, MD players, VCRs, TV, etc.).
Connect the red plug to the R jack, and the white plug to the L jack.
When connecting
a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
11
1
i:
*
i;;
LINE OUT JACKS
This unit can output
analog sound signal through these jacks.
Use a cable with RCA phono
plugs to connect
audio equipment
with LINE IN (analog
input) jacks.
Do not connect an equipment to the LINE OUT terminals and
VlDEO/AUX
terminals
simultaneously.
Otherwise,
noise is
generated and malfunction occurs.
CD DIGITAL OUT (OPTICAL)
JACK
This unit can output
CD digital
sound signals through
this jack.
Use an optical
cable to connect
digital
audio
equipment
(DAT
deck, MD recorder,
etc.).
Remove
the dust cap (_) from the CD DIGITAL
OUT (OPTICAL)
jack. Then,
connect
an optical
cable plug to the CD DIGITAL
OUT (OPTICAL)
jack.
When the CD DIGITAL OUT (OPTICAL)
jack is not being used
Attach the supplied
dust cap.
SUPER WOOFERS
_ JACKS
Connect
optional
powered
sub woofers
with built-in-amplifiers
to the jacks.
POWER
VIDEO/AUX
MD
_
...........
[
To play equipment connected to the VIDEO/AUX or MD jacks
proceed as follows.
Press VIDEO/AUX or MD.
When a equipment
connected
to the VIDEO/AUX
jacks
is
played:
press VIDEO/AUX
When a equipment
connected
to the MD jacks is played:
press MD.
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX is pressed, "VIDEO" is displayed initially. It
can be changed to "AUX" or "TV".
With the power on, press POWER while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust
the sound
level of the external
source
When the sound level of the external
source
is much higher or
much lower than that of other function sources, adjust it as follows.
1
Press VIDEO/AUX
or MD and play the equipment.
2
Press 4_1
or I_1_ so that the sound level becomes
the same
as that of other function
sources.
During recording, the sound level can not be adjusted.
0
.J
0
Z
0
m
m
Z
I-
0
ENGLISH
20
Publicidad
