Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
IT
PT
GENERAL CULTIVATING
See Figure 1
Shallow cultivating less than 5cm. deep can be used to
disrupt weeds and aerate soil, without injuring nearby
plant roots. It should be done often so that weeds do not
grow large and cause tangling in the tines of the unit.
The two outer tine blades can be removed from the unit to
allow a more narrow cultivating width.
To remove the two outer tines:
■ Remove the battery from cultivator.
■ Remove the hitch pins from the holes on the ends of
the tine shaft.
■ Remove the outside tine blades and felt washers from
the tine shaft.
■ Place hitch pins in the holes that were uncovered when
felt washers were removed.
ADJUSTMENTS
NOTE: The unit will not operate properly if the tines are
installed incorrectly. If you notice a problem with the
cultivating operation of the unit, check for proper tine
positioning.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
cultivator from any power source when making
adjustments.
ADJUSTING WHEEL POSITION
See Figure 5
The wheel position of the unit is adjustable.
TRANSPORT
CAUTION!
Before transporting the application, switch off the
motor.
The tines and the unit maybe damaged even if you move
the application with the motor switched off, e.g. over solid
ground. Prevent the tines from touching the ground by
NL
SV
DA NO
FI
HU CS RU
English
carrying out the application by its guide bar.
CLEARING TINES OF FOREIGN OBJECTS
During operation, a stone or root could become lodged
in the tines, or tall grass or weeds may become wrapped
around the tine shaft.
To clear the tines, release the trigger lever. Unplug the
tiller, and dislodge or remove any obstacles from the tines
or tine shaft.
To ease removal of tall grass or weeds that are wrapped
around the tine shaft, remove one or more of the tines
from the tine shaft. See Tine Removal and Installation in
the manual.
ADJUSTING CULTIVATOR SPEED AND DEPTH
The wheel / drag stake assembly may be used to help
control the cultivator's speed and depth of operation.
To adjust the height of the wheel / drag stake
assembly:
■ Unscrew the adjustment knob and remove.
■ Adjust the wheel / drag stake assembly to the desired
position.
■ To place the wheel / drag stake assembly in a deep
position, insert the knob through the first hole. For a
shallow position, insert the knob through the second or
third hole.
■ Replace the adjustment knob. Tighten securely
MAINTENANCE
12
RO PL
SL
HR ET
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard
or cause product damage.
WARNING:
Always wear safety goggles or safety glasses
with side shields during cultivator operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING:
Before inspecting, cleaning or servicing the
machine, remove the battery and wait for
all moving parts to stop. Failure to follow these
instructions can result in serious personal injury
or property damage.
LT
LV
SK BG
Publicidad
