Publicidad
Idiomas disponibles
Idiomas disponibles
,_
WARNING: Do not at any time make any
adjustment
to
the
unit
without
first
stopping
engine
and
disconnecting
spark plug wire.
TineRemoval andReplacement
NOTE: All four tines should be replaced at the same
time, because they will wear evenly through normal
use,
•
Push the On/Off switch to Off (O) position to stop
engine and tines and disconnect spark plug to
avoid accidental starting.
•
It may be necessary to lay the cultivator back in a
horizontal position on a flat level surface with the
upper handle touching the ground.
•
Remove the click pin from each end of the tine
shaft and slide the tines off the shaft.
•
Slide new tines on with hubs facing out. The four
tines are marked with letters A and B, Place one
A and one B tine on the tine shaft, See Figure 16,
•
Secure new tines to shaft with click pins,
NOTE: It may be necessary to wash the dirt off the
tines and shaft for ease of removal,
A Tine
Hul:
Figure
16
-Click
Pin
StoringYourCultivator / Edger
•
Thoroughly clean the unit and inspect for any
loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts, or
bolts.
•
Wipe equipment with a oiled rag to prevent rust,
•
Never store the unit with fuel in the tank where
fumes may reach an open flame or spark.
•
Always store unit in cultivator mode (all four tines
on unit) to avoid tip over.
Engine
If the unit will be stored for longer than 60 days:
•
Clean engine by removing dirt and debris with a
cloth or brush from cooling fins, air intake screen,
levers, and linkage. This will help ensure
adequate cooling engine speed,
•
Drain all gasoline from the gas tank into a
container and dispose in accordance with federal,
state, and local regulations,
•
Start the engine and allow it to run until it stalls,
This ensures that all gasoline has been drained
from the carburetor,
•
Allow the engine to cool and remove the spark
plug and put 1 oz. (30ml) of high quality motor oil
into the cylinder, Pull the starter rope slowly to
distribute the oil and reinstall the spark plug,
NOTE: Remove the spark plug and drain all of the oil
from the cylinder before attempting to start the unit
after storage,
•
When changing oil, refer to the Maintenance
section, Dispose of the oil in accordance with
federal, state, and local regulations.
•
Store unit in a clean, dry area, Do not store next
to corrosive materials such as fertilizer,
•
For more compact storage, store unit in the
shipping position with the upper handle folded
toward engine, See ASSEMBLY section for
details,
12
Publicidad
