Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
J
,_
_
__
//
SCHEDULE
_"°'_ _._,_..
_
_
/
Check Engine Oil
.,
Change Engine Oil
_
_
z
Clean Air Filter
_
z
Check Spark Plug
_
q_
Check Spark Arrester
Rocker Arm Clearance
_
NOTE:
Maintenance,
replacement,
or repair
of
the emission
control
devices
and system
may be
performed
by any non-road
engine
repair
estab-
lishment,
individual
or authorized
service
dealer.
In order to assure peak performance of your engine,
inspection of the engine exhaust port may be
necessary after 50 hours of operation, If you notice
lost RPM, poor performance, or general lack of
acceleration, this service may be required, If you feel
your engine is need of this inspection, refer to a Sears
service center, DO NOT attempt to perform this
process yourself as engine damage may result from
contaminants envolved in the cleaning process for the
port,
,_
WARNING: Always stop engine and dis-
connect spark plug wire before cleaning
or doing any kind of maintenance
on
your cultivator / edger.
Checking 0il
,_
WARNING: To prevent extensive engine
wear and damage
to the unit, always
maintain the proper oil level in the crank-
case. Never operate the unit with the oil
level below the bottom of the dipstick.
•
Check oil before each use.
•
Stop engine and allow oil to drain into the
crankcase,
•
When checking
oil, the unit must be laid back
in the horizontal position
on a flat surface with
the upper handle touching the ground,
See Figure 8,
•
Keep dirt and debris out of the engine, Clean the
area around the oil fill plug/dipstick before
removing it,
Figure 8
•
Remove the oil fill plug/dipstick and wipe off oil,
Reinsert it all the way back in.
•
Remove the oil fill plug/dipstick and check oil
level. Oil should be up to the top of the dipstick.
Refer to Figure 4,
•
If the level is low, add a small amount of oil to the
oil fill hole and recheck. Repeat until the oil level
reaches the top of the dipstick, See Figure 9,
NOTE: Make sure the O-ring is in place on the oil fill
plug/dipstick when checking and changing the oil
O-Rin¢
Oil Fill
_,_
Plug/Dipstick
Figure
9
Changing 0il
•
Remove the oil fill plug/dipstick,
•
Tip the unit back or away from the air filter to pour
the oil out of the oil fill hole and into a container,
•
Wipe up any oil residue on the unit and clean up
any oil that may have spilled, Dispose of the oil
according to federal, state, and local regulations,
Publicidad
