Publicidad
Bicelelo)(-ttareveydialemcieli(e(=)
If you are experiencing problems with the tuner, first check the following items:
© Make sure the power cord is securely plugged into the electrical outlet.
¢ Make sure all the cords are properly connected to the amplifier.
© Make sure the antenna(s) are properly connected and positioned.
° Make sure the power switch on the amplifier is turned on.
If problems still persist, check the items in the list below.
Should any problem persist after you have checked the following items, consult your nearest Sony dealer.
Problem
Cause
Solution
There is no sound.
The source setting on the amplifier may not
Set the source setting on the amplifier to
o
be correct.
TUNER.
You can't tune in stored stations.
The frequency of the station may not be
Store the frequency of the station again.
correctly stored.
The reception is poor.
The antenna may not be correctly
Adjust the position of the antenna.
positioned.
The station may not be properly tuned in.
Adjust the tuning knob to tune in the
station.
The signal may be weak.
Connect an external antenna (For FM
broadcasts) or run an extra length of wire
from the -r screw connector (for AM
broadcasts).
There is severe hum and/or background
The tuner may be picking up noise from
Move the tuner and antenna away from the
noise.
another electrical device.
source of the noise.
The antenna may not be correctly
Adjust the position of the antenna.
positioned.
The antenna wire may be picking up other
Use coaxial anterina cable.
radio signals that are interfering with
reception.
Another wire (FM antenna cable,
Move all cords away from the AM antenna.
connecting cord, power cord, etc.) may be
touching the AM antenna.
One antenna is being used for more than
Use a distributor.
one tuner and/or witha TV.
You cannot scan stored stations.
The scan operation has not been activated.
Press TUNE MODE so that PRESET
appears.
The appropriate display does not appear.
The microcomputer in the tuner is not
Turn the power off. Hold down5
and press
working properly.
MENU. Then press POWER to turn the
power on again. This erases any preset
stations stored in the memory ancl returns
to display to the default language (English).
RDS information does not appear on the
The radio station to which you are tuned is
Contact the radio station and find out
display. Instead, a message appears.
not providing a particular RDS service, or
whether or not they actually provide the
the service is out of order.
RDS service in question. If so, the service
may be temporarily out of order.
66
Publicidad
