Kohler K-11830 Guia Del Usuario página 10

Sensor Wire
Discard the
plaster guard.
6. Install the Sensor
Install the Bezel
Loosen the screws in the plaster guard.
Remove the plaster guard and discard.
Feed the sensor wire through the back of the bezel.
Position the bezel over the screw heads and turn 1/8 turn
counterclockwise.
Confirm that the "UP" label is at the top.
Tighten the screws.
Connect the Sensor
Connect the sensor to the wire harness and feed the wire into the
wall.
Position the sensor in front of the bezel with the wire on the back
of the sensor to the right.
Push the sensor into place.
1124216-2-C
Bezel
10
Sensor
Kohler Co.