Kohler K-11830 Guia Del Usuario página 8

Plaster Guard
5. Install the Supplies
NOTE: The diameter of the faucet hole cutout is 1-3/4" (44 mm).
The diameter of the sensor hole cutout is 1-3/8" (35 mm).
NOTE: The diameter of the supply inlet opening is determined by
the ell diameter.
Install a 1/2" supply pipe to the valve assembly.
At the point where the supply will exit the wall, install a drop ear
ell flush or slightly behind the finished wall.
Feed the sensor wire through the sensor mount and plaster
guard, leaving 1-1/2" (38 mm) minimum of exposed wire
protruding.
Secure the sensor wire harness to the wall.
Run the sensor wire through the tube or opening to the control
box mounting location.
Temporarily connect the water supply to the supply ell.
Turn on the water.
1124216-2-C
Secure the wire
harness to the wall.
1-1/2"
(38 mm)
Ell
8 Kohler Co.