Kohler K-11830 Guia Del Usuario página 11

Ø 1/2" (13 mm)
Hole
7. Install the Control Box
NOTE: Locate the control box underneath the countertop, between
the ell and the water supply stop.
NOTE: Do not connect the control box wiring in this step.
Drill a 1/2" (13 mm) hole at the control box location.
Route the sensor wire through the hole.
Remove the control box cover. Set the screws and cover aside.
Feed the wires through the back of the control box.
Mark the screw hole locations using the control box as a template.
Make sure the wire harness hole in the wall is covered by the
box.
Install appropriate wall anchors (not provided) at the marked
hole locations.
Attach the control box to the wall with two screws (not
provided).
Kohler Co.
Control Box
Screws
Screw Hole
Locations
11 1124216-2-C