Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
of handle
(12)
(13)
For machines with U handle
e Loosen the handle installation bolts (12).
e Insert the handle into the handle joint (13) fully.
e After making sure that the handle is installed properly, tighten the
installation bolts (12) to secure the handle.
e Secure the throttle wire with the clip wire (20) as shown in the figure
for easy operation.
For machines with Loop handie (CEN)
* Fix a barrier to the left side of the machine together with
the handie for operator,s protection.
e Do not adjust position of the loop handle too close to the
control grip. Keep not less than 25cm distance between the
handle and the grip.
(a distance collar is provided for this purpose.)
For machine
with Loop handle
e Attach the handie to the shaft.
e install the handle joint (22) on the handle. Insert the installation
bolt M6 x 45 (23) through the hole in the handle. Semitighten the
installation bolt M6 x 45 (23).
¢ Adjust the handle to the desired position over 200 mm away from
the rear grip (24) and tighten the installation bolt M6 x 45 (23).
13
Publicidad
