Makita RBC220 Manual De Instrucciones Original página 14

| GB
Mounting of protector A
To meet the applicable safety provisions, only the tool/protector combination as indicated in the table must be used.
RBC220, RBC250 , RBC225, RBC255
Star brade Protector for metal cutter blade
Grass-pasture
Be sure to use genuine MAKITA cutter blade or nylon cutting head.
e The cutter blade must be well polished, free of cracks or breakage.
If the cutter blade hits against a stone during operation, stop the
engine and check the blade immediately.
e Polish or replace the cutter blade every three hours of operation.
For RBC220, RBC250, RBC225, RBC255
e The outside diameter of the cutter blade must be 230 mm (9-1/16"").
Never use any blades surpassing 230 mm (9-1/16'') in outside
diameter.
RBC221, RBC251, RBC226, RBC256
Nylon cutting head Protector for nylon cutting head
RST250
Nylon cutting head Protector for nylon cutting head
CAUTION:
A The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place in not permitted.
14
For RBC225, RBC255, RBC226, RBC256
RBC220, RBC250, RBC221, RBC251
e Install the clamp (3) on the drive shaft so that the projection of
the clamp (3) is inserted into the opening between the gear case
(1) and the shaft.
Secure the protector (4) with the installation bolts M6 x 30 (2).
For RST250
e Attach the protector (7) to the shaft.
e Insert the nut M6 (6) into the hex hole in the protector (7).
+ Secure the protector with the installation bolt M6 x 45 (5).
NOTE:
Do not tighten the installation bolt M6 x 45 (5) excessivley.