Makita RBC220 Manual De Instrucciones Original página 18

|
Caution during operation:
if the throttle lever is opened fully in a no-load operation, the engine
rotation is increased to 10,000 rpm or more. Never operate the engine
at a higher speed than required and at an approximate speed of
6,000 - 8,000 rpm.
Poignée en "U"
Poignée simple
(CEN)
Loop Handle
18
e First place the machine on the ground.
e Give a gentle push on the primer pump (12) repeatedly (7 - 10 times)
until fuel comes into the primer pump.
e Move the choke lever (11) to the top position ( Na} ).
e Firmly hold the holder case by your left hand as illustrated.
e Slowly withdraw the starter grip until resistance is felt and continue
with a smart pull.
e Do not pull out the starter rope to its full extent and do not allow
the starter handle to be retracted without control, but ensure that
it is retracted slowly.
e Repeat the starting operation until initial ignitions are heard.
e Depress the choke lever ( |@| } and pull the starter rope again
until the engine starts.
e As soon as the engine starts, immediately tap and release the
throttle, thus releasing the half-throttle lock so that the engine can
run in idle.
e Run the engine for approximately one minute at a moderate speed
before applying full throttle.
Starting the warm engine
e As described above except without moving the choke lever (choke
lever remains in the down position ( [4] ).
Stopping
e Release the throttle lever (6), (7) fully, and when the engine rpm
has lowered, push the stop switch (1), (9) to STOP" position.
Engine will stop.