A&D GX-L Serie Guia De Inicio Rapido página 8

EN.
Key operations
Key operations affect how the balance functions. Normal key
operations during measurement are "press and release the key
immediately" or "press the key". Do not "press and hold the key (for
two seconds) unless specifically required.
Key
Turns the display on and off. Only the standby indicator is displayed when the display is
turned off. Weighing mode is enabled when the display is turned on. When the password
function is enabled, the password input display is displayed. Refer to "16-2. How to Input
the Password at the Start of Weighing" in the separate instruction manual.
This ON:OFF key is always enabled. Pressing the ON:OFF key during operation will
interrupt operation and turn the display off.
Adjusts the sensitivity of the balance using
the internal mass (GX-L series only).
Switches the weighing unit stored in the
function table.
In weighing mode, turns the minimum
weighing value on and off.
In counting or percent mode, enters
sample storing mode.
Depending on function table settings,
either stores the weighing data or outputs
the data to a printer when the value is
stable (factory default = output).
Sets the display to zero.
Refer to "About zero-point operation", "About tare", "About measurement range" in "4-2.
Basic Operation (g, kg, ct, mom)" in the separate manual.
When pressed and released
Press the key
(Press and release
the key immediately)
When pressed and held
Displays other sensitivity adjustment menu
items.
Enters the self check function mode.
Refer to "6-2. Self Check
Function/Automatic Setting of
Minimum Weighing Value by ECL".
Enters function table mode. Refer to "9.
Function Table".
Runs the repeatability check function when
pressed and held for another 2 seconds
after the function table menu is displayed
(GX-L series only). Refer to "17.
Repeatability Check Function" in the
separate instruction manual.
Enters the mode for changing the unit
mass registration number in counting
mode.
Depending on changes to the function
table:
 Outputs "Title block" and "End block" for
GLP/GMP reports.
 Displays the data memory menu.
 Enters the mode for the density number
in flow measurement.
8
Press and hold the key
for 2 seconds
(for 2 seconds)