Publicidad
Idiomas disponibles
Idiomas disponibles
8 .2 . Automatic energy saving mode
Sleep mode is activated automatically if the watch receives
no light for 72 hours. The second hand points permanently to
the 12 o'clock position during Sleep mode. The hour and min
ute hands remain in the last position attained. To start the
watch again, expose the solar dial briefly to a light source
or press button 2. As the watch does not attempt to start
signal reception in energy saving mode, the time continues
in quartz mode – the hands are then positioned at the stored
time. If you are located within the range of one of the five
signal transmitters, the time is synchronised at the next
automatic synchronisation. Alternatively, you can also carry
out manual synchronisation.
9 . General information
Water resistance can be affected by external influences
which can cause moisture to enter the watch. We recommend
to have your watch regularly serviced by your Junghans
retailer. Battery changes, service work and bracelet repairs
should also be carried out by an authorised Junghans
specialist.
Avoid direct contact with alcoholbased perfume, disinfect
ants, chemical detergents (e.g. petrol or paint thinner), as
this will shorten the life of the glass, seals and leather strap.
Your watch is fitted with a quality strap which has under
gone multiple tests in our company workshops. Should you
choose to replace your strap, please use a strap of identi
cal quality, preferably an original Junghans strap. Both the
watch and the strap can be cleaned using a slightly damp
cloth. Metal bracelets are best cleaned with a small brush
and soapy water.
10 . Technical information
Setting time with
good reception:
Time zone setting
possible (UTC):
Switching between
CET and CEST:
time adjustment to the
time signal transmitters:
Second display
change:
Operating temperature:
Subject to technical changes.
Declaration of conformity
Uhrenfabrik Junghans GmbH & Co. KG hereby declares that
this wristwatch complies with the essential requirements
and other relevant provisions of Directive R&TTE2014/53/EU.
A corresponding Declaration of Conformity can be requested
at info@junghans.de.
approx. 2 minutes
(depending on reception mode)
+ 14 / - 12 hours
automatic
1:58 and 40 seconds
according to the set local time
(CEST: 2:58 and 40 seconds)
Halfsecond increments Date
approx. 5 seconds before
midnight
0° to +50°C
11 . Water resistance
Marking
Washing,
rain,
splashes Shower
No mark
No
No
3 BAR
Yes
No
5 BAR
Yes
No
10 BAR
Yes
Yes
20 BAR
Yes
Yes
30 BAR
Yes
Yes
Water resistance as specified by DIN is a design engineer
ing feature which is susceptible to external influences such
as shock, fluctuations in temperature, UV light and direct
contact with cosmetics and cleaning products (greases and
acids). The "3–30 BAR" condition is thus only applicable for
brand new watches. We recommend you have the watch ser
viced at regular intervals.
12 . Frequently asked questions
The second hand makes 4 half-second steps every
2 seconds.
The watch has a low charge level.
Place the watch under a light source.
The totalisers are at the 12 o'clock position and do not
move .
You are in chronoscope mode. Press button 2 to switch to
the time display.
The second hand is at any position .
Check whether the crown is pulled out. If so, push the crown
to position A. If not, the watch has a low charge level. Place
the watch under a light source.
The watch shows the correct second but the wrong hour .
The time zone is not set correctly. Pull the crown to position
C. Turn the crown clockwise or anticlockwise to change the
time by one hour. The second hand then acts as an hour
indicator.
The watch has no signal reception although I am in the
reception area of a transmitter .
Check whether you have set the correct reception area.
Change this if necessary (see Manual time synchronisation
with change of reception area).
Instructions for use
Diving
without
scuba tanks
Bath
Swimming
(snorkelling)
No
No
No
No
No
No
Yes
No
No
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
8
Publicidad
