Publicidad
Idiomas disponibles
Idiomas disponibles
Inlets
ProfiClear Premium Fleece have different inlets for supplying water
Inlet
DN 110
Leadthrough G2 (installed)
Leadthrough 50 mm (closed with
sealing plug)
Connecting Bitron Premium
When using the UVC clarifier Bitron Premium the entire water supply can run into the filter system via
the UVC clarifier. Select a suitable UVC clarifier version based on the required flow rate.
For assembly you require the OASE connection set, art. no. 92560.
Connect the UVC clarifier. ( Operating instructions Bitron Premium)
Use the triangular plate to fasten the Bitron Premium to the container.
Connecting Bitron Eco
When using the UVC clarifier Bitron Eco a maximum flow rate of 15000 l/h is recommended. For
greater flow rates, it is possible to connect an additional filter pump to the container. (→ Connecting
the filter pump)
Hand-tighten the bolt connections.
Position the 90° inlet bends so that they are pointing downwards.
Connect the filter pump as described in the operating manual.
A non-return valve is installed in the connection for the filter pump to prevent water from re-
turning. If a filter pump each is to be connected to the Bitron and to the connection for the fil-
ter pump, the pump on the connection for the filter pump can be switched on/off as required
without any problems.
ProfiClear Premium Fleece
500
750
1×
1×
1×
2×
2×
2×
Connection
Connection UVC clarifier Bitron Premium
Connection filter pump via hose sleeve 50 mm
Connection UVC clarifier Bitron Eco (alternative
to UVC clarifier Bitron Premium on DN 110)
EN
Proficlear0344
51
Publicidad
