Publicidad
Idiomas disponibles
Idiomas disponibles
10
LOCATION AND PLACEMENT:
DANGERL RISK OF EXPLOSION OR FIRE! DO NOT PLACE UNIT
IN AN AREA WHERE FLAMMABLE GAS VAPORS MAY BE
PRESENT. A SPARK COULD CAUSE AN EXPLOSION OR FIRE!
DANGERL RISK OF UNIT BURSTING! DO NOT LOCATE THE UNIT IN
FREEZING ENVIRONMENTS!
1. This unit should be installed indoors by a qualified serviceman in a non-
freezing, dry environment away from damaging winds and rain. If any
part of the unit becomes frozen, excessive pressure may build up in the
unit which could cause it to burst resulting in possible serious injury to
the operator or bystanders. Normal precautions should be taken so that
excess moisture does not reach the electrical controls or the power unit.
2. It should be placed in an area away from flammable or combustible material.
These types of material should be kept at least 20 feet away from the gas-
fired units.
WARNING: RISK OF ASPHYXIATION! USE THIS PRODUCT ONLY IN
WELL VENTILATED AREAS! THE EXHAUST CONTAINS CARBON
MONOXIDE, A POISONOUS, ODORLESS AND INVISIBLE
GAS. BREATHING THIS GAS CAN CAUSE SERIOUS INJURY,
ILLNESS & POSSIBLE DEATH.
3. Avoid small areas and exhaust fans. Combustion becomes difficult and
carbon monoxide may result in these areas. Allow enough space for servic-
ing. Some codes will require certain distances from walls and flooring. Two
feet away from the walls should suffice.
4. This unit should only be placed on a level surface to ensure proper lubrication
for the water pump while operating. NEVER spray water directly on the
unit.
5. DO NOT place unit in an area:
a. where flammable gas vapors may be present.
b. with insufficient ventilation.
c. where there is evidence of oil or fuel leaks.
ELECTRICAL:
1. Installation of this unit should be performed by a qualified serviceman and
all electrical installation must conform to all local, state and national codes,
including NFPA No. 70 (NEC) National Electrical Code. In Canada; Refer
to the CSA C22.1 Canadian Electrical Code Part 1.
WARNING: RISK OF ELECTROCUTION! THIS UNIT MUST BE
CONNECTED TO A PROPERLY GROUNDED OUTLET.
2. This unit comes to you with the wires terminating in a junction box inside
the cabinet. You must supply the incoming power source.
3. Ensure electrical supply is identical to the specifications listed on the
pressure washer data plate.
4. Ensure all connections are secure and covers are replaced.
GAS PIPING:
1. Installation of this unit should be performed by a qualified serviceman and
all gas piping must conform to all local, state and national codes, including
the National Fuel Gas Code ANSI Z223.1/NFPA No. 54. In Canada; Refer
to the CSA B149.1 Gas Installation Code.
2. Turn off gas and electricity before starting installation or service.
3. The gas line to the burner should be a separate supply from the meter
because of the burner demand. Use new pipe and locate it with future
INSTALLATION
Operator's Manual
Publicidad
