Publicidad
Idiomas disponibles
Idiomas disponibles
HOT WATER OPERATION:
1. Follow the steps outlined for "COLD WATER OPERATION."
2. Move the burner switch to the ON position. On initial start-up, water will
begin turning hot in approximately 60 seconds and will reach maximum
temperature in approximately 3 minutes, provided the trigger remains
squeezed. The burner will stop firing when the trigger is released.
3. Set thermostat to the desired setting.
WARNING
RISK
COULD
BECOME
OPERATION. BE CAUTIOUS WHEN ADJUSTING PRESSURE
OR
CONTROLLING
ASSEMBLY.
At this point, the unit is operating as a hot water pressure washer. Be
certain to be extremely cautious when adjusting the pressure and control-
ling the trigger gun/dual lance assembly to avoid the possibility of burns.
NOTE: The burner is equipped with a safety lock-off device. If the
pilot fails to ignite within 60 seconds, the gas valve locks OFF.
Simply release the trigger for approximately another 60 seconds
and repeat. During operation, the burner may cease and start oc-
casionally because of the thermostat setting.
IMPORTANT WHEN COLD WATER IS BEING PUMPED INTO
THE HEAT EXCHANGER AND THE BURNER IS ON,
CONDENSATION MAY FORM ON THE COIL AND DRIP.
THIS WILL GIVE THE APPEARANCE OF A LEAKING COIL
PARTICULARLY IN COLD HUMID WEATHER.
CLEANING WITH DETERGENTS:
This feature is designed for use with mild detergents only. Since the
cleaning solution travels through the heat exchanger coil, do not use cor-
rosives as they will cause extensive damage as well as pose a consider-
able safety hazard.
1. Be certain to wear protective safety attire as stated on pg. 18.
2. Prepare detergent solution according to label directions. (Never pump
acids, alkalines, abrasive fluids or solvents through the unit.)
3. Fully immerse the strainer end of the clear vinyl detergent hose into the
detergent solution.
4.
Adjust the amount of detergent desired by turning the detergent
adjustment knob to the desired setting.
5. To apply solution, unlock the trigger gun and squeeze the trigger. In
a few moments a detergent/water mixture will exit the nozzle. Start
spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps avoid
streaking. Allow to soak briefly. Avoid working on hot surfaces or in
direct sunlight to minimize the chances of the detergent drying, which
may result in damaging surfaces. Be certain to clean a small section
at a time.
6. To rinse, turn the detergent adjustment knob to the OFF position. It will
take about 30 seconds to purge all detergent from the line. For best
rinsing results, start at the top and work down.
NOTE: If machine is equipped with remote box (es), read pg. 24 for
information on detergent solenoid.
7. Siphon a gallon of water through the detergent system after each use.
This prevents the possibility of corrosion or detergent residue causing
mechanical problems during the next use.
Operator's Manual
OPERATING INSTRUCTIONS
OF
BURN!
THE
WATER
VERY
HOT
DURING
THE TRIGGER
TEMPERATURE
HOT
WATER
GUN/DUAL
LANCE
19
Publicidad
