Mi-T-M Corporation HG Serie Manual De Instrucciones página 5

SAFETY WARNINGS
If you smell gas, shut off the gas supply to the appliance, extinguish any
open flame, and test all joints with a soap solution. If the odor persists,
call you gas supplier immediately.
Follow all safety instructions provided with the materials you are spray-
ing. Use of a respirator may be required when working with some mate-
rials. Do not use this pressure washer to dispense hazardous materials.
RISK OF ELECTROCUTION OR ELECTRIC SHOCK
Serious injury or death could result from improper installation.
Serious injury or death could occur if the pressure washer is not prop-
erly grounded. Your pressure washer is powered by electricity and may
cause electric shock or electrocution if not used properly.
Electrical shock may occur if pressure washer is not operated properly.
Serious injury or death may occur if electrical repairs are attempted by
unqualified persons.
Serious injury or death may occur from contact with electricity.
Installation of this unit including all electrical connections must com-
ply with all local, state and national codes. (Standards to be followed
include NFPA No. 70/NEC National Electrical Code.In Canada; Refer to
the CSA C22.1 Canadian Electrical Code Part 1)
This unit must be connected to a grounded, permanent wiring system;
or an equipment-grounding conductor must be run with the circuit con-
ductors and connected to the equipment-grounding lead on the unit.
Make sure the pressure washer is connected to a properly grounded
source which provides correct voltage and adequate fuse protection.
Disconnect from power source when not in use or when making repairs.
Do not attempt to light the pilot manually as the electronic spark ignition
lights the pilot automatically.
Never operate pressure washer with electrical enclosures open, re-
moved or damaged.
Do not touch machine while standing in water or with wet hands. Never
let the electrical supply or any connections lay in the water.
DO NOT direct spray on or into electrical installations of any kind! This
includes electrical outlets, light bulbs, fuse boxes, transformers, the unit
itself, etc.
DO NOT allow metal components of the pressure washer to come in
contact with live electrical components.
Any electrical wiring or repairs performed on this pressure washer
should be done by authorized service personnel in accordance with lo-
cal and national electrical codes.
Before opening any electrical enclosure, always shut off the pressure
washer, relieve pressure and disconnect the pressure washer from the
power source. Allow pressure washer to cool down. Never assume the
pressure washer is safe to work on just because it is not operating. It
could restart at any time!
RISK OF INJECTION OR SEVERE CUTTING INJURY
Serious injury or death could occur from high pressure spray penetrating
the skin.
Keep clear of nozzle and spray! Never put your hand, fingers or body
directly over the spray nozzle.
Never point the high pressure discharge stream at persons.
Operator's Manual 5