Publicidad
Idiomas disponibles
Idiomas disponibles
HYDROSAUNA FUNCTIONS
"Steam bath"
This function generates steam at a controlled
temperature and it may include scents distribution.
The reference temperature for the steam control is
the one indicated on the screen.
Select this option (press ENTER) to see the
following submenu:
1. On / Off (On/Off Function).
2. Timer (cycle duration).
3. Temperature ("Steam" temperatures definitions).
NOTE:
The duration of the cycle in progress and the working temperatures read by the tempera-
ture sensor are indicated in the information area on the screen.
"On/Off"
Press ENTER to start or finish the Steam Bath.
The Steam Bath is started only when the set temperature is reached.
The message shown on the screen indicating the sauna is being ready indicates the
temperature hasn't been reached the set values yet.
In this context, the Timer countdown doesn't start even if you see the seconds counting
down.
When the set temperature is reached the message disappears and the timer countdown
starts according to the pre-set duration (see the following function).
NOTE:
• By turning this function off the boiler gets into the maintenance phase, which is
indicated by the message "Discharge Phase" .
• The low water level of the boiler for a long time or if the temperature isn't reached
within 60 minutes will cause the cycle to finish.
• If during the discharge phase a new steam bath cycle is initiated, the system assures
the conclusion of the 1st phase (charge + discharge for 30 seconds) and discharges for
at least 1 minute (2nd phase) after which the new cycle automatically starts.
60
12:05
(0)
01/04
Hydro 5
On/Off
Lenght
Lenght
20:00
Temp.
29.8 C
12:12
03/12
Hydro
Steam bath
Radio
07:11
(0)
01/12
Discharge
phase
Publicidad
