makro PROFESSIONAL Metro Professional GGW1001 Manual De Instrucciones página 26

EN
MODELS WITH WASH PUMP THREEPHASE GHW1300 - GHW1300S:
CHECK THE DIRECTION OF ROTATION OF THE WASH PUMP MOTOR, ACCORDING TO THE INDICATION ARROW. IN CASE OF
REVERSE ROTATION, REVERSE TWO PHASES OF THE LINE OF THE POWER CABLE IN THE MAINS SOCKET, L1, L2 OR L3.
ROTATION CAN BE CHECKED BY THE BACK-PUMP IMPELLOR ROTATION.
BEFORE REVERSE THE LINE CABLE, YOU MUST DISCONNECT THE MACHINE FROM THE MAINS POWER SUPPLY BY
SWITCHING THE SERVICE SWITCH AND THE MAINS POWER SWITCH ON THE WALL OFF.
2.5 TEMPERATURES
3 - RINSE AID AND DETERGENT DISPENSING
Only use detergents and rinse aids specific for industrial machines. Do not use normal washing up
liquid. Do not use detergents for domestic machines.
Ask a specialist in chemical products for the correct choice of products to use and their
quantities. ATTENTION! MACHINE LIVE: Remove the lower panel of the machine to adjust the
dispensers.
Glass/dishwashers lower panel remove screws
3.1 RINSE AID QUANTITY – RINSE AID DISPENSER
The rinse aid dispenser is always installed and it works automatically.
For the dosing type built-in, please refer to section 2.1 "Technical Specification".
The thermostats are pre-set at the following temperatures: 55°C for the washing water (tank) and at
85°C for the rinse water (boiler).
The tank thermostat cannot be adjusted whereas the boiler thermostat can; in case of settling, turn
the knob (image) on the thermostat to increase or reduce the rinse temperature.
VERIFY THE WASH PUMP MOTOR ROTATION.
Passthroughs lower-panel remove screws
9