Publicidad
Idiomas disponibles
Idiomas disponibles
Long-term stoppage
If the machine is not going to be used for quite some time, you have to empty the rinse aid dispensing device to avoid
crystallizations and damages to the pumps: remove the priming pipes from the rinse aid containers and soak them in a container
of clean water, run some wash cycles and empty the machine completely.
To finish, switch off the main on/off switch and shut off the water inlet tap; only put the rinse aid priming pipes back into its
containers when you start the machine again.
DO NOT LEAVE THE MACHINE SWITCHED ON IF IT IS NOT USED FOR SOME TIME OR IF THE OPERATOR IS NOT
ABLE TO MONITOR IT DIRECTLY. NEVER LEAVES THE MACHINES UNATTENDED,
7 – ERRORS /PROBLEMS
PROBLEM
THE MAINS LIGHT FAILS TO SWITCH
ON
THE WASH CYCLE FAILS TO START
POOR WASHING RESULTS
INSUFFICIENT RINSING
THE GLASSES AND CUTLERY ARE
STAINED
WATER IN TANK AFTER DRAINING
16
POSSIBLE CAUSE
Mains not connected
The machine has still not filled wash
tank and boiler.
The holes of the spray arms are
clogged or scale is obstructing them.
Not
enough or unsuitable
detergent or rinse aid
Plates/glasses not positioned
correctly.
Too low wash temperature
The set cycle is unsuitable
The spray nozzles are clogged. Scale
in boiler.
The rinse aid is unsuitable or is not
dispensed correctly.
Water hardness above 12°dF or high
dissolved salt content.
The drain pipe is not positioned
correctly or is partially obstructed.
Drain Pump not working properly.
POSSIBLE SOLUTION
Check the electric mains connection.
Wait for the boiler lamp to switch on.
Dismantle and clean the spray arms.
Check the type and quantity of detergent.
Arrange the plates/glasses correctly.
Check the temperature on the display
(only on hood dishwashers); if it is below
50°, call the technical assistance service.
Increase
the
wash
cycle
especially
if
the
crockery/cutlery
particularly dirty or there are stubborn
leftovers to clean.
Check if the nozzles are clean and if the
softener (if installed) works correctly.
Check the rinse aid container and if it is
suitable for the type of mains water. If the
problem consists, contact the technical
assistance service.
Check if the pipe and the drain of the
machine are obstructed and if the drain is
positioned
too
high;
refer
connection diagram.
In case of broken drain pump, contact the
technical assistance service.
EN
duration,
is
to
the
Publicidad
