makro PROFESSIONAL Metro Professional GGW1001 Manual De Instrucciones página 30

EN
5.4 – DRAIN THE WASH TANK
5.5 – DAILY USE HOOD DISHWASHER
The panel shown in the manual and in the graphics may
contain functions which are not present on your machine.
MODELS SANS WITHOUT DRAIN PUMP
(refer to section 2.1 Technical Specifications)
Turn the machine off by pressing
overflow and wait for the tank to empty. Place the overflow back into
the tank and close the door. Deactivate the general wall switch.
Please note, water wash tank should be daily drained out 3-4 times.
MODELS WITH DRAIN PUMP
(refer to section 2.1 Technical Specifications)
Open the door, remove the overflow pipe and close the door.
Turn the machine off by pressing the on/off
emptying of the tank automatically. Drain pump will be activated until the
total drain of the tank and the wash cycle LED will be on.
In order to reactivate the machine, it is therefore necessary to place the
overflow pipe back into the tank, close the door and press the on/off
button. Otherwise, if finished using the machine, deactivate the
general wall switch.
Please note, water wash tank should be daily drained out 3-4 times.
(refer to section 2.1 Technical Specifications).
Lift the hood and insert the rack.
LOADING THE MACHINE
Remove any solid leftovers from the plates (bones, peel, nuts etc);
leave the plates to soak in cold water if there are any stubborn
leftovers, such as dried cheese, egg etc.
Put the glasses in the basket with their stem upwards.
Use the cutlery basket for cutlery. Put the cutlery loose in the basket,
preferably with the handle at the bottom. Be careful not to injure
yourself on the fork prongs and knife blades.
On first daily machine switch on, wait for the wash tank display
55°C and boiler display 85°C
, open the door, remove the
in order to initiate the
What to do and what happens
After inserting the wash tank
filters into the tank and the
overflow pipe, close the hood.
Turn on the main wall switch.
Than, press
button of the control panel. The
boiler and tank water-loading LED
indicator turn on. Once the boiler
and tank loads have been
completed, wait for
the water to warm up to the
working temperature.
the on/off
13