makro PROFESSIONAL Metro Professional GGW1001 Manual De Instrucciones página 29

Once the cycle has started, the wash cycle LED indicator turns on. If the door is opened during the cycle, the program stops.
Once the door has been closed again, the program resets itself; to restart the cycle, press the
5.3 – REGENERATION CYCLE ONLY FOR MODELS WITH WATER SOFTENERS
The panel shown in the manual and in the graphics may
contain functions which are not present on your
machine.
Salt for machines is fundamental for the regenerative cycle of the softener installed in the machine. To top-up, use the funnel
supplied and clean any spilled salt from inside the tank. NB: REMOVE ANY SPILLED SALT FROM THE TANK
IMMEDIATELY, otherwise it could damage the surface of the tank with rust or similar marks.
Attention: use exclusively specific salt for dishwasher and not kitchen salt!
The salt compartment takes approximately 1 kg of grain salt.
The salt compartment is located on the bottom of the tank. Take the basket out, unscrew the cap and pour salt in using the
funnel.
Before screwing the cap back on, remove any spilled salt near the opening. Top-up with salt when there
is no water in the tank so that the washing water cannot get into the water softener. Always unplug the machine from the
mains power supply before doing this operation. Remember to plug the machine back into the mains socket after
completing the operation.
When using the machine for the first time, after you fill with salt, add some water to the salt container.
12
Insert the basket
LOADING THE MACHINE
Remove any solid leftovers from the plates (bones, peel, nuts etc);
leave the plates to soak in cold water if there are any stubborn
leftovers, such as dried cheese, egg etc.
Put the glasses in the basket with their stem upwards.
Use the cutlery basket for cutlery. Put the cutlery loose in the basket,
preferably with the handle at the bottom. Be careful not to injure
yourself on the fork prongs and knife blades.
On first daily machine switch on, wait for 15 minutes after the boiler
LED indicator to turn off.
CHOOSING A WASH PROGRAM: 2' or 3'.
You can select the wash program using the cycles selector: pressed
select cycle 3' LED on. Unpressed 2', LED off.
To start the wash cycle, press the
Once the program has finished, the wash cycle LED indicator turns
off and the boiler LED indicator
Remove the rack
What to do and what happens
To activate the regeneration cycle:
Switch off the machine pressing
Open the door and remove the overflow pipe.
Close the door.
. The regeneration cycle starts
Press cycle button
about 20 minutes, the regeneration cycle finishes and the machine
shuts off. Open the door, replace the overflow pipe and close the
door.
Deactivate the general wall switch.
cycle button.
cycle button
turns on.
(refer to section 2.1)
. After
EN